IKO Rubershield Eco 100g/m2 Roll 50 x 1.5m (11402000)

Made from 3 layer polypropylene, this roll can be used within ventilated and unventilated pitched roofing. Available in either 1.5m or 1m width, this 50m roll has a mass/weight of around 100g/m2 and a thickness of 0.35mm. Work should commence with the installation of IKO Eaves Protection Strip, laid parallel to the eaves and fixed with clout nails to every rafter 25mm from the top edge. The bottom edge should be dressed and detailed over the fascia, eaves support board and tilt fillets into the externally mounted gutter position, a minimum material overhang of 50mm or to the centre line of the gutter system is desirable. Do not allow the material to sit in direct contact with the gutter as this may obstruct water flow. Horizontal overlaps must be created to shed water out and down the slope. Roof pitch and overlaps should be set for the rafter pitch and roof construction accordingly. With the printed side uppermost, the IKO Rubershield membrane should be laid to overlap the IKO Eaves Protection Strip by the required horizontal lap requirement, and fixed with clout nails to each rafter 25mm in from the top edge of the lower sheet and 25mm from the exposed edge of the upper sheet.